在ABB機器人編程中,大家常用的停止程序執行的指令為stop,不過在RAPID語言中還有很多中停止方式,下面將做介紹:
1.指令SystemStopAction立即停止所有任務中的所有機器人
\Stop; 類似于通過停止按鈕實現 的正常程序停止
\StopBlock:如上所述,但要重 新啟動,必須移動PP
\Halt:這類似于類別0 停止,即 引發電動機關閉狀態、程序執行和 所有運動任務中機器人運動的停止。 在重新啟動程序執行之前,必須按 下電機啟動按鈕
2.指令Stop當前移動指令在機器人停止前完成。 重新啟動將繼續程序執行
\NoRegain:重新啟動時(比如在 點動之后),機器人不會返回停止點
\AllMoveTasks:所有機器人都會 停止

In ABB robot programming, the commonly used instruction to stop program execution is stop. However, there are many stopping methods in RAPID language. The following will introduce them:
1. Command SystemStoppAction to immediately stop all robots in all tasks
\Stop; Similar to a normal program stop achieved through a stop button
\StopBlock: As mentioned above, but to restart, PP must be moved
\Halt: This is similar to category 0 stop, which triggers the motor shutdown state, program execution, and the cessation of robot motion in all motion tasks. Before restarting the program, the motor start button must be pressed
2. Command Stop: The current movement command is completed before the robot stops. Restarting will continue program execution
\NoRegion: When restarting (such as after jogging), the robot will not return to the stop point
\AllMoveTasks: All robots will stop
